• Caution

    Please, read these notes with care.
    Save these instructions for later use.
    All notes and warnings found on the machine are to be followed.

  • Installing the machine

    The machine must be installed only by an Authorised Service Engineer.

    A safe, level position is necessary, when installing the machine, with sufficient space all round to operate it. The machine is to be protected from moisture. If moving the machine, ensure that the castor brakes are off, and push on the stand, not the machine.

    Ensure there is at least 1 metre of free space between the operator side of the machine and a wall or barrier. To provide access to the mains switch, the opposite side of the machine must be at least 150mm from a wall or barrier. Do not place surrounding furniture or other objects where your path may be obstructed.

    Electrical danger

    The machine may only be connected to a voltage of 230V/50Hz or 115V/60 Hz,depending upon model.

    The mains plug may only be connected with a socket having an installed protective contact! The protective effect will be compromised by the use of an extension line without a protective grounding conductor. All interruptions of the protective grounding conductor, within or outside of the machine, are prohibited. The device is double pole fused! When fuse failure occurs, electrical machine parts can still carry voltage. When making the connection to the mains power, be aware of the connection values on the nameplate. Inspect the voltage setting on the device’s power input module. Run the supply lines in such a way, that no-one may trip over them. Do not place any objects upon the supply line. When the machine is not in use over a long period of time, it should be disconnected from the power supply. In this way, damage would be prevented in the event of excess voltage. Protect the device from moisture. When moisture enters the machine, there is the danger of electrical shock. Never open the machine except the top cover. For reasons of electrical safety, the machine may only be opened by authorized Service Agents.

    Operating safety

    Never reach into the machine when it is running! This could only occur if a safety interlock were to fail.

    The danger of injuries exists, through pulling in and crushing on the rotating rollers. In addition, keep long hair and parts of loose clothing far from the machine in operation. If a safety interlock fails, your Service Agent must be contacted immediately!

    In order to prevent damage to the machine, only factory authorized accessory parts should be used.

    Cleaning the machine

    Prior to cleaning the exterior of the machine, it should be disconnected from the power supply. When cleaning the machine, do not use liquid or spray cleaners, but only a cloth dampened with water.

  • Cleaning sensors

    When cleaning sensors use only non-flammable airdusters, eg. part number 9103707C. Other types may use flammable propellants, which could result in fire or explosion.

    Allow machine to be checked by the Service Agent

    In the following cases, the mains plug must be unplugged and the device left for the authorized Service Agents:

    • When the mains cable or plug is worn or damaged.
    • When water or other liquid has entered the device.
    • When the device does not function properly, in spite of following the instructions provided.
    • When the device has fallen down or the housing is damaged.
    • When there are noticeable differences in the normal operation of the machine.

    Spare Parts

    When repair work is carried out, only original spare parts or spare parts corresponding to the original parts may be used.


    Do not disassemble the machine any further than is described in this handbook. Other than the top cover, the opening of the machine by unauthorized personnel is not permitted. Repairs may only be carried out by an authorized Service Agent.

    Modification is not permitted:

    For safety reasons, your own reworking and modifications are not permitted.

  • Tip

    Please contact your Service Agent, for all questions relating to service and repair. In this way, you ensure the operational safety of your machine.

Date created:
03/18/2013 02:20:47
Last updated:
03/18/2013 08:17:02