1. Begin creating a job (see Creating a job).

    2. In the Document selection box, press New.

    3. Enter a document name.

    4. Select Form type (usually General type).

    5. Select document size. If you change default dimensions, size will change to Custom.

    6. Enter the Address position and Paper type (standard or glossy). If the document is pre-folded, enter the number of leaves it folds into.

    7. Enter the paper weight and document thickness and weight will automatically calculate, or press Computed and enter actual figures.

    8. If using barcode or OMR marked documents, enter the definition name. Press Region of Interest to specify label position.

    9. Enter the location and size of the label and press OK.

    10. If Doc Id mode is to be used, select On. This reads a label character and compares its string value with the string entered in Doc Id. This confirms that the correct document type is used.

    11. The shield setting controls the amount of shielding over the lower pick-up wheel, and should not normally require adjustment. However, if stream-feeding or erratic double feeds occur, try moving the shield back (ie. reducing the percentage). If documents are not properly picking up, move it forward.

    12. Press Save when done.

      1. The document is now fully defined and is available for use.

      2. Attention

        Documents can also be created from the Menu screen if you have appropriate access rights.

Date created:
03/05/2018 08:18:52
Last updated:
03/07/2018 07:43:40
Product(range):
DS-1200 G4i
Print